I'm sure other people will do the same. Just thought it might be useful to add the link in case anyone else does just that. AndyOlds , 30 Jul Joined: 3 Sep Country:. Select the supplier or trade you require, enter your location to begin your search. Please select a service and enter a location to continue You must log in or sign up to reply here.
Show Ignored Content. Related Threads. Replies: 3 Views: 1, Thankyou very much. Top tip. My control also showed the display and the flame symbol, so appeared to be working, but red light at receiver.
Dismantled plastic housing for thermostat and discovered evidence of a battery leak at the "far end" that's hard to see without dismantling. Can I replace it with a Dayton digistat RF 3 room thermostat? Laszlo March I just had a new boiler fitted and I already had wireless thermostat working before. I need to get the time to flash to be able to change it. Thanking you in anticipation. Stokesy March Fantastic answer by Allen. Sanded the terminals and it now works a treat Simon October Hi, I have moved into a property which uses the drayton rf2 wireless system.
Is there a way u can just turn the heating on and off when required instead of using the timer?? Please help!! Thanks Lucy October I had to use a combination of two of the suggestions on here, being foil and Allen's answer at the bottom and, as if by magic, the unit is working perfectly again.
No more having to get up at 6am to turn the heating on manually! Many thanks. Jemima January Cleaned the contacts as the last batteries had leaked and, hey presto, I have heating :D Joy January Allen's answer at the foot of this thread was spot on. I've noticed that the batteries do not sit snuggly in their compartments - they rattle about - so the electrical connections to the internal circuitry is sometimes a bit flaky e.
To get a tight connection: - take the batteries out - get some aluminium foil and fold it to fit into the bottom of battery compartment on top of, and across the width of the little metal plate connector that the batteries normally touch. Corroded metal is a poor electrical conductor. I use this technique in the kids' toys' battery compartments as well when they haven't touched them for ages and the batteries have leaked.
Saved me a fortune when a Lego Robotics control unit when snafu. The Kernel October RAY October This worked for me by removing the 4 batteries and pressing both bottons as allen suggestedl marc March I'd cleaned out the mess straight away but wondered if I could do more. Sanded it down and it 'learned' 1st time. The hours. Press "SET? The Digistat 2 comes with the following preset programme. Press the "SET? Press the Yes — button again. The time. Continue to press the "SET? Continue to press "SET?
The Digistat can be operated in one of three modes. When the batteries start to run low a battery icon will flash in the.
Please replace batteries with 2 x 1. When the battery icon alone is shown in the display , the batteries.
Re-activate by replacing the batteries. Press once, the display. After 5 seconds will start. T o exit override press. Once the time has been set. Once the temperature has.
T o exit press or. Ask a question. Jon Mccahon, 1 comment 5. Harry Catling, Answer this question Send. Diane Hallford, 1 comment 2. The time is wrong by half an hour how do I change it? Susan Fletcher,
0コメント